The Audi A4 B8, A5 8T and Q5 8R are great drives, but their multi-link front suspension has eight control arms, four on each side. After enough kilometres, speed humps and potholes, the ball joints and bushes in those arms wear, and the first sign is usually a knock or clunk from the front end. This guide explains what each arm does, the signs of wear, what you can check, and which arms we stock. Several of these arms also suit the A6 C7, A7 4G, S4, S5 and Porsche Macan.
1. How the B8 front suspension is laid out
Each front wheel is held by two lower arms and two upper arms:
- Lower arms: a straight forward arm and a curved rear arm. The curved rear arm carries a lot of the braking load.
- Upper arms: a front (forward) upper arm and a rear upper arm. Together they locate the top of the hub and control camber.
Each arm has its own ball joint and bush, so one can wear out while the others are still fine. That's why it pays to find the worn arm rather than guess.
2. Signs of a worn control arm
- A knock or clunk from the front over speed humps, driveway lips or rough roads.
- A clunk or shimmy under braking, often from a worn curved lower arm bush.
- Vague or wandering steering at highway speed, or the car tramlining on grooved roads.
- Uneven wear on the inside or outside edge of the front tyres.
- An alignment that won't hold, or can't be set within spec.
- A creak at low speed when turning or going over bumps.
3. What you can check
Look: with a torch, check each ball joint boot for splits or grease leaking out, and each bush for cracks, perished rubber or the inner sleeve sitting off-centre.
Feel: with the front safely on stands, rock the wheel at 12 and 6 o'clock, then at 9 and 3 o'clock. Play can come from a ball joint, a tie rod end or a wheel bearing, so have someone watch each joint while you rock it. A pry bar gently levered against each arm can show movement in a bush.
A mechanic with a hoist can usually pinpoint the worn arm quickly. If the noise is a creak rather than a clunk, the upper arms are a common place to start looking.
4. Front lower control arms (curved rear arm)
- Basco BCA1191 Front Left Lower Control Arm, $104.95
- Basco BCA1190 Front Right Lower Control Arm, $104.95
- Basco BCA1190 & BCA1191 Front Lower Control Arm Pair, $199.95
Supplied with the ball joint fitted (17mm cone). Listed for the A4 and A4 Avant B8 (2008 to 2017), A4 allroad B8, A5 8T coupe, convertible and Sportback (2007 to 2017), A6 C7, A7 4G, Q5 8R (2009 to 2017) and Porsche Macan (2017 on), as listed. These are the curved rear lower arms, so check the shape of your old arm before ordering.
5. Front upper control arms (rear position)
- Basco BCA1123 Front Left Upper Control Arm (Rear Position), $52.95
- Basco BCA1121 Front Right Upper Control Arm (Rear Position), $52.95
- Basco BCA1121 & BCA1123 Front Upper Control Arm Pair, $95.95
Supplied with the ball joint fitted (16mm cone). Listed for the A4 B8, A5 8T, Q5 8R, the supercharged 3.0L S4 B8 and S5 8T, and the Porsche Macan, as listed. They don't suit the newer A4 and A5 (B9 and F5) or the Q5 FY.
In Australia the front right is the driver side and the front left is the passenger side.
6. Why replace control arms in pairs?
Bushes and ball joints on both sides have done the same kilometres. If one side has worn out, the other usually isn't far behind. Replacing both together keeps the front end feeling even, and you only pay for one wheel alignment. It isn't compulsory, but it's often the better value over the life of the car. Our pairs cost less than buying both sides separately.
7. While the bonnet's up: struts that won't hold
A bonnet that drifts down or won't stay up on its own is a common annoyance on older A4s and A5s, and a falling bonnet can hurt. The bonnet uses two gas struts, and it's best to replace both so they push evenly.
- Monroe ML5741 Max-Lift Bonnet Gas Strut, $56.95 each
- Monroe ML5741 Max-Lift Bonnet Gas Strut Pair, $103.95
Listed for the A4 B8 (incl. Avant and allroad) and A5 8T (coupe, convertible and Sportback), 2007 to 2017. Prop the bonnet securely before removing the old struts.
Replace now or keep an eye on it?
- Replace any arm with ball joint play or a split ball joint boot.
- Replace arms with cracked, torn or badly perished bushes, especially if you have a clunk under braking.
- Monitor light surface cracking on a bush with no noise or movement, and recheck at your next service.
- Replace bonnet struts as soon as the bonnet won't stay up on its own.
DIY difficulty and safety
- Upper control arms: moderate to hard. Access is tight, and the pinch bolts at the hub can seize.
- Lower control arms: moderate to hard. You'll need a ball joint separator, and the bush bolts should be tightened with the suspension at ride height so the bushes aren't pre-loaded.
- Bonnet struts: easy. Support the bonnet first.
Some suspension bolts on these cars are single-use, so check your workshop manual for which ones need replacing. Always get a wheel alignment after replacing control arms. Use stands on firm, level ground, never just a jack, and tighten everything to the torque in your workshop manual. Steering and suspension are safety-critical. If you're unsure, have a qualified mechanic do the work.
FAQ
Do these arms suit the Audi S4 and S5?
The BCA1121 and BCA1123 upper arms are listed for the B8 S4 and 8T S5 with the 3.0L supercharged V6. For lower arms on an S model, send us your VIN and we'll check.
Do they fit the B9 A4 or the new Q5?
No. These arms are listed for the B8 / 8T / 8R generation, not the B9, F5 or FY.
Do I need an alignment afterwards?
Yes, always.
Are the ball joints included?
Yes. Each arm comes with its ball joint already fitted.
Browse all Audi A4, Audi A5, Audi Q5 and Porsche Macan parts.
Not sure which part fits your Audi?
Check the fitment table on each product page, read our How to Check Fitment guide, or just ask us. Send your rego or VIN to sales@hoorooautomotiveparts.com.au or call the HOOROO Crew on (07) 5495 1839, and we'll confirm the right part before you order. Everything ships from our Sunshine Coast QLD warehouse, and spend $160 or more and shipping is free Australia-wide, applied automatically at checkout.
Find it. Fit it. Fair Dinkum™.
The HOOROO Crew
This article is general information only. Always have your vehicle inspected and repaired by a qualified mechanic.