The Audi Q7 4L, Volkswagen Touareg 7P and Porsche Cayenne 92A share a lot under the skin, including their front lower control arms. They're heavy, capable SUVs that are often used for towing, which is hard on front suspension. Many of them also run the 3.0L V6 TDI diesel, where the water pump is a common job as the kilometres climb. This guide covers both: the signs of a worn front lower arm, the signs of a failing V6 TDI water pump, what to check, and which parts suit your car.
1. Front lower control arms: what they do
The front lower control arm locates the bottom of the wheel hub, carries the lower ball joint, and takes much of the vehicle's weight and braking load through its bushes. On a big, heavy SUV, those bushes and ball joints work hard, especially on rough roads or when towing.
2. Signs of a worn front lower arm
- A knock or clunk from the front over bumps, speed humps or rough roads.
- A clunk or shimmy from the front under braking.
- Vague or wandering steering, or the car pulling to one side.
- Uneven or rapid wear on the inside or outside edge of a front tyre.
- A split ball joint boot, or cracked and perished bushes.
3. What you can check
Air suspension first: if your car has air suspension, put it in jack or workshop mode before lifting it. Your owner's or workshop manual explains how.
Look: check the ball joint boot for splits and the bushes for cracks or rubber pushing out of the housing.
Feel: with the front safely on stands, rock the wheel at 12 and 6 o'clock. Play can be the ball joint or the wheel bearing, so have someone watch the joint. A pry bar gently levered against the arm will show bush movement. A mechanic can confirm which part is moving, and also check the upper arms, tie rod ends and sway bar links.
4. The arms we stock
- Basco BCA1260 Front Left Lower Control Arm, $267.95
- Basco BCA1288 Front Right Lower Control Arm, $267.95
- Basco BCA1260 & BCA1288 Front Lower Control Arm Pair, $525.95
Supplied with the ball joint and bushes fitted. Listed for the Audi Q7 4L (2006 to 2015), Porsche Cayenne 92A (2010 to 2018) and Volkswagen Touareg 7P (2010 to 2019) across their petrol, diesel and hybrid engines, as listed. They don't suit the Q7 4M, the earlier Cayenne 955 / 957 or Touareg 7L, or the newer Cayenne 9YA and Touareg CR.
Check your old arm: the Q7 4L was built with more than one front lower arm design over its life. Compare the photos with the arm on your car, or send us your VIN.
In Australia the front left is the passenger side and the front right is the driver side. Both sides have done the same kilometres, so many owners replace them as a pair. The pair costs less than buying both separately, ships free, and you only pay for one alignment.
5. The 3.0L V6 TDI water pump
On the 2.7L and 3.0L V6 TDI, the water pump sits at the front of the engine behind other components. It has no fixed replacement interval, so it's replaced when it starts to fail, or during other front-of-engine work.
Signs:
- The coolant level keeps dropping, or there's a sweet smell after driving.
- Coolant residue or drips at the front of the engine, below the pump.
- A whining, grinding or rumbling noise from the front of the engine.
- The temperature gauge running hot, especially when towing or in traffic.
- A low coolant warning or coolant temperature fault code.
Check: a cooling system pressure test is the quickest way to confirm where coolant is escaping. Hoses, the radiator and the expansion tank can also leak.
Listed by engine code for the Audi Q7 4L 3.0 TDI (BUG, CASA, CJGA, 2006 to 2011), VW Touareg 7L and 7P V6 TDI and 150TDI (2006 to 2019), and Porsche Cayenne Diesel 9PA (CASA, 2007 to 2010), as well as V6 TDI versions of the Audi A4, A5, A6, A8 and Q5. Note that the pump's Cayenne listing is the earlier 9PA Diesel, not the 92A. It doesn't suit petrol, 4-cylinder TDI or V8 TDI models, or engine codes not listed.
Replace now or keep an eye on it?
- Replace a lower arm with ball joint play, a split boot, or torn or badly perished bushes.
- Replace the water pump if it's leaking, noisy, or the engine is running hot.
- Monitor light bush cracking with no noise or movement, and a steady coolant level with only faint dried residue. Recheck at every service.
DIY difficulty and safety
- Front lower control arms: hard. These are heavy parts. Tighten the bush bolts with the suspension at ride height so the bushes aren't pre-loaded, use new nuts, and get a wheel alignment afterwards.
- V6 TDI water pump: hard. Access varies by model. Fit the new gasket supplied, refill with the correct VW-spec coolant and bleed the system.
Use stands rated for the vehicle's weight on firm, level ground, never just a jack, and tighten everything to the torque in your workshop manual. Steering and suspension are safety-critical. If you're unsure, have a qualified mechanic do the work.
FAQ
Is the same arm used on the Q7, Touareg and Cayenne?
Yes. Basco lists BCA1260 (left) and BCA1288 (right) for the Q7 4L, Cayenne 92A and Touareg 7P, which share this front suspension.
Does the arm suit the Cayenne Turbo or Touareg V8 TDI?
Yes. It's also listed for the Cayenne GTS, Turbo and Turbo S, the Q7 V12 TDI and the Touareg V8 TDI.
Does the WP8098 suit the 92A Cayenne Diesel?
It isn't listed for it. Send us your VIN and we'll check what suits.
Do I need an alignment after replacing lower arms?
Yes, always.
Browse all Audi Q7, VW Touareg and Porsche Cayenne parts.
Not sure which part fits your Q7, Touareg or Cayenne?
Check the fitment table on each product page, read our How to Check Fitment guide, or just ask us. Send your rego or VIN to sales@hoorooautomotiveparts.com.au or call the HOOROO Crew on (07) 5495 1839, and we'll confirm the right part before you order. Everything ships from our Sunshine Coast QLD warehouse, and spend $160 or more and shipping is free Australia-wide, applied automatically at checkout.
Find it. Fit it. Fair Dinkum™.
The HOOROO Crew
This article is general information only. Always have your vehicle inspected and repaired by a qualified mechanic.