Chery Omoda 5 Engine Mounts, Water Pump & Rocker Cover Gasket: Warning Signs

Basco BEM4120 right hand engine mount to suit Chery Omoda 5

The Chery Omoda 5 is still a fairly young car in Australia, but plenty are now past the point where rubber mounts, seals and the water pump start to show their age, especially on cars that do a lot of stop-start driving or towing in summer heat. This guide covers three common jobs on the Omoda 5 / C5 petrol engines: engine mounts, the water pump and the rocker cover gasket. It explains the signs, what you can check yourself, and which parts suit which engine.

First, know your engine

The Omoda 5 and C5 have been sold with two turbo petrol engines in Australia. The standard models (BX, EX and FX) use the 1.5L turbo (SQRE4T15C), and the GT uses the 1.6L turbo (SQRF4J16). Some parts suit both, and some suit only one, so check your engine before ordering. It's shown on your registration papers, and we can confirm it from your rego or VIN.

1. Engine mounts: vibration and clunks

Engine and transmission mounts are rubber-and-metal blocks that hold the engine in place and soak up its vibration. Over time, the rubber cracks, sags or separates from the metal.

Common signs:

  • More vibration through the steering wheel, seat or floor at idle, often worse with the air-con on or in Drive at the lights.
  • A clunk or thud when you pull away, back off the accelerator, or shift between Drive and Reverse.
  • The engine visibly rocking when someone blips the throttle with the bonnet up.

What you can check: with the bonnet up and the handbrake firmly on, look at the right-hand mount (on the driver's side of the engine bay) for cracks, splits or rubber pulling away from the metal. Have a helper hold the brake hard and gently shift between Drive and Reverse while you watch from the side (never stand in front of the car). A little movement is normal. A big lurch or a clunk isn't.

Parts (1.5L and 1.6L turbo Omoda 5 / C5):

When one mount fails, the others take more load, so it's worth inspecting all of them while you're there.

2. Water pump: coolant leaks and overheating

The water pump circulates coolant through the engine and radiator. It has a bearing and a seal inside, and when the seal starts to go, coolant usually escapes through a small weep hole on the pump body.

Common signs:

  • The coolant level dropping between services, or a low coolant warning.
  • Dried coolant residue (often a crusty, coloured stain) on or below the pump.
  • Drips of coolant under the front of the car after it's been parked.
  • A whining or grinding noise from the pump area, or play in the pump pulley.
  • The temperature gauge reading higher than normal.

What you can check: with the engine completely cold, check the coolant level in the expansion tank against the marks. Look around the pump and below it with a torch for wet patches or residue. Never open a hot cooling system, as the coolant is under pressure and can cause serious burns.

Part (1.5L turbo Omoda 5 / C5, 2022 to 2025, as listed):

If your engine is overheating, stop driving as soon as it's safe. Running an engine hot can do far more expensive damage than a water pump.

3. Rocker cover gasket: oil leaks and a burning smell

The rocker cover (valve cover) sits on top of the engine, sealed by a rubber gasket. Heat cycles slowly harden that rubber, and once it loses its seal, oil starts to weep out.

Common signs:

  • Oily residue along the edge of the rocker cover.
  • A burning oil smell after a drive, from oil dripping onto hot exhaust parts.
  • Oil in the spark plug wells, found when the coils or plugs come out. This can cause misfires.
  • Oil use between services with no other obvious leak.

What you can check: with the engine cold, look along the joint between the rocker cover and the cylinder head with a torch. Fresh, wet oil on the joint usually means the gasket. Oil higher up, around the oil filler cap, may simply be a cap seal or spillage from a top-up.

Part (1.6L turbo SQRF4J16 only: Omoda 5 GT / C5, Tiggo 7 / 7 Pro and Jaecoo J7, as listed):

We don't currently list a rocker cover gasket for the 1.5L engine. Ask us and we'll check what's available.

Replace now or keep an eye on it?

  • Engine mount: replace if the rubber is split or separated, or if there's a clear clunk on take-off. Mild extra vibration with no visible damage can be monitored, but have it checked at your next service.
  • Water pump: replace if it's actively leaking, noisy or has pulley play. A faint dry stain with a steady coolant level is worth watching closely and checking regularly.
  • Rocker cover gasket: a light weep can be monitored, but replace it if oil is dripping onto the exhaust, reaching the spark plug wells, or the level is dropping.

DIY difficulty and safety

  • Engine mounts: moderate. The engine or transmission has to be supported with a jack and a block of timber while the mount is changed. Fit the new mount loosely, let the engine settle, then tighten to the torque in your workshop manual.
  • Water pump: moderate to hard, depending on access. The cooling system needs draining, refilling with the coolant type in your owner's handbook, and bleeding properly to remove air.
  • Rocker cover gasket: moderate. The coils and other parts on top of the engine need to come off, the surfaces must be clean, and the bolts tightened evenly in the correct order.

If you're not sure about any of these jobs, a qualified mechanic can do them quickly with the right tools and torque specs.

FAQ

Do the engine mounts fit both the 1.5L and the 1.6L GT?
Yes. The BEM4120 and BEM4122 are listed for both the 1.5L turbo and the 1.6L turbo GT Omoda 5 / C5. Check the listing's fitment table for the full list, including Tiggo 7 models.

Does the WP9002 water pump fit the Omoda 5 GT?
The WP9002 is listed for the 1.5L turbo only. For the 1.6L GT, contact us and we'll check.

Can a bad engine mount cause a clunk that sounds like suspension?
Yes. A clunk on take-off or when shifting between Drive and Reverse is more likely a mount. A clunk over bumps is more likely suspension.

Should I change the coolant when I change the water pump?
Yes. The system has to be drained anyway, so refill with fresh coolant of the type in your owner's handbook.

Not sure which part fits your Omoda?

Check the fitment table on each product page, read our How to Check Fitment guide, or just ask us. Send your rego or VIN to sales@hoorooautomotiveparts.com.au or call the HOOROO Crew on (07) 5495 1839, and we'll confirm the right part before you order. Spend $160 or more and shipping is free Australia-wide, applied automatically at checkout.

Find it. Fit it. Fair Dinkum™.
The HOOROO Crew

This article is general information only. Always have your vehicle inspected and repaired by a qualified mechanic.